Instructions

46
|
Snapmaker Enclosure
|
47
How to Use
A built-in smart sensor in the 24 BEAM A350-3 of the enclosure is designed to detect
the status of the folding doors. When any one of the doors is opened, the laser or CNC
process will stop automatically and a notification will be shown on the Touchscreen.
To resume the process, close the door and follow the instructions on the Touchscreen.
If you need to open the door frequently and do not expect the ongoing process to be
paused, you can enter Home -> Enclosure -> Settings to disable the Door Detection.
When the machine is connected to a computer with the USB cable, and is operated
on a laser process through Snapmaker Luban, the Door Detection is not available. In
this case, do not open the enclosure door, otherwise the laser will stop emitting, which
leads to failure of the engraving job.
Door Detection applies only to laser and CNC functions, excluding 3D printing.
Moreover, Door Detection is applicable only when the machine is run through USB flash
drive and Wi-Fi.
Safety Goggles must be worn before opening the door during a laser or CNC process.
When the machine is connected to computer with USB cable, and is operated on a CNC
process through Snapmaker Luban, the Door Detection is not available. In this case,
the ongoing CNC process is not affected when any of the enclosure doors is opened/
closed.
3.3 Door Detection (For Laser & CNC
）
Guides & Pictures / Snapmaker
Resources
This guide is subject to change. For the latest version, go to:
https://snapmaker.com/download
We are here for you whenever you need general information or technical support:
[e-mail]
For any sales inquiries, you can reach out to us at:
[e-mail]
You can purchase products in our official online store:
https://shop.snapmaker.com
Share anything you want with other Snapmaker users at our forum:
https://forum.snapmaker.com