Instructions

44
|
Snapmaker Enclosure
|
45
How to Use
3. Switch off the machine, unplug the toolhead cable, then detach the toolhead and platform.
4. Attach the needed toolhead and platform, then connect the cable(s) to the controller.
To use 3D printing function inside the enclosure, please place the filament as below.
If the machine is currently equipped with 3D printing components, make sure to unplug
the Heated Bed cable before detaching the Heated Bed.
To avoid injury, make sure to remove the CNC bit before detaching the CNC module from
the machine.
To attach the Heated Bed, make sure to switch off the machine before connecting the
Heated Bed cable. Do not plug or unplug any cables with the machine powered on.
Check if all the cables are properly connected before powering on the machine. Wrong
connection may cause damage to the machine.
Toolhead X Axis Y axes Z axes Enclosure Power Module Touchscreen