Instructions / Assembly

We are happy to answer your questions or provide support:
Monday - Friday | 7:30 - 4 PM PST
1-888-959-4471
4
Install the Latch
• Attach Latch Slide (I) onto gate structure (A) using
Latch Mounting Plate (M) and screw.
• The “U” shaped section of the Latch Slide (I) should
wrap around vertical post.
• The Mounting Plate (M) will insert into the Latch
Slide (I) keeping it attached to the gate structure.
• The top of the Mounting Plate (M) should face
towards the latch vertical post.
• Use supplied screws to attach Mounting Plate (M) to gate structure (D).
• Once complete, slide the Latch Slide (I) down into the locked position.
4.1
Position Gate Stop
• Position Gate Stop (L) to the center of the vertical post but
do not secure.
• Close gate with latch still in locked position (lowered).
• Slide Gate Stop (L) up until it interlocks with Latch Slide (I).
• The screw holes in the Gate Stop (L) should be facing the
gate (D).
• Make sure Latch Slide (I) does not slide up when doing this.
This is the correct position for the top Gate Stop (L). Mark
this position with a pencil.
4.2
Attach the Gate Stop
• Open the gate. You should need to slide the Latch Slide (I) up
to do this.
• Once gate is open, attach the Gate Stop (L) in marked position
using supplied screws.
• Attach bottom Gate Stop (L) in desired position using
supplied screws.
C1
C2
C1
C1
C2
C1
3.1
Install the Gate
• Attach bottom gate Hinge (C) to vertical post
using supplied screws. Align with the bottom
most edge of the post.
• Slide assembled gate over bottom Hinge
Bracket (C1) to attach gate.
• Slide top Hinge Bracket (C2) into top Gate
Corner (D1) and attach to vertical post using
supplied screws.
3.2
Install Gate Panel
• To install Gate Panel place panel against Post
and Rail and attach by using screws to secure
wire along its edge.
• When installing wire or lattice make sure gate
is hanging properly. The tension created by
hanging wire or lattice can cause the gate to
become misaligned.
Use wire or lattice
panels of your
choosing.
You can either place
wire or lattice on front
or back side of gate.
Slide post caps
onto the posts.
Slide Hinge onto
Gate and secure.
Slide Gate
onto Hinge.
Attach
Hinges
with
screws.
Attach Wire
or Lattice
with screws
Attach Wire
or Lattice
of your
choosing.
Assembled
Gate
Assembled
Gate
A
B
U
(M) Mounting
Plate
Lock
“U” side
wraps post
Insert into
Latch Slide
(I) Latch
Slide
Gate
Closeup
D
holes face gate
Latch Slide (I) down in
locked position
Slide Gate Stop (L)
up to interlock with
Latch Slide (I)
NOTE: Secure components with PVC glue
if a permanent t is desired.