User's Manual
Table Of Contents
- 17 MARS-3102 User Manual_0904
- 17 MARS-3102 User Manual_0731
- Safety Information
- Contents
- Using This Manual
- Introduction
- Getting Started
- Navigation
- Scanner Operations
- OBD Direct Operations
- Component Test Operations
- Scope Multimeter Operations
- Ask-a-Tech Operations
- Information Operations
- Vehicle History Operations
- Data Manager Operations
- Help Operations
- System Settings Operations
- Maintenance
- Software License Agreement, North America
- Index
- 文件2
- 17 MARS-3102 User Manual_0731
- RF Exposure Information (SAR) CCS
122
Maintenance Display Device
:$51 ,1*
Risk of explosion.
• The Lithium battery is factory replaceable only, incorrect replacement or tampering with
the battery pack may cause an explosion.
Explosion can cause death or serious injury.
Battery Safety Guidelines
IMPORTANT:
The battery pack contains no user serviceable components. Tampering with the battery pack
terminals or housing will void the product warranty.
Keep the following in mind when using and handling the battery pack:
• Do not short circuit battery pack terminals.
• Do not immerse the Display Device or battery pack in water, or allow water to enter the unit or
battery pack.
• Do not crush, disassemble, or tamper with the battery pack.
• Do not heat the battery pack to over 100°C (212°F), or dispose of it in a fire.
• Do not expose the battery pack to excessive physical shock or vibration.
• Keep the battery pack out of reach of children.
• Do not use a battery pack that appears to have suffered abuse or damage.
• Charge the battery pack in the appropriate charger only.
• Do not use a battery charger that has been modified or damaged.
• Use the battery pack for the specified product only.
• Store the battery pack in a cool, dry, well ventilated area.
NOTE:
i The battery pack should be used within a short period of time (about 30 days) after charging to
prevent loss of capacity due to self-discharging.
If long-term storage of the battery pack is necessary, it should be stored in a in cool, dry, well
ventilated place with a 30 to 75 percent state of charge to prevent loss of characteristics.
To prolong the life of your battery, power off the unit or place it into hibernation mode when not in
use. The display Device has a built in charger that recharges the battery on demand whenever it
is connected to a power source.
Replacing the Battery Pack
If the battery pack no longer hold a charge, contact your sales representative to order a new one.
IMPORTANT:
Replace the battery pack with original Snap-on replacement parts only.