Full Product Manual

HOOK-RING ADAPTER
HH. Bend hook on strap back and insert sewn loop end of strap over one end of Adapter.
II. Slide to other side and slip sewn loop end over other end of Adapter.
JJ. Position strap in center of Adapter as shown and tuck hook around strap out of the way as shown.
KK. Adapter can also be installed over strap at any location for adjustable anchoring.
HH II JJ
KK
STRAP LINK E-STRAP CONNECTOR
LL. Pull back on the E-Fitting leaver and insert into Link as shown.
MM. Insert other end of E-Fitting fully into the Link as shown.
NN. Release leaver and jiggle until securely clicked in place.
OO. To remove pull back lever on E-Fitting and disengage.
LL MM NN
OO
STRAP HOOK ON E-STRAPS
EE. Move E-Fitting out of the way and slip split section of Hook onto the loop at end of strap.
FF. Pull Hook through strap loop all the way until in place as shown.
GG. Hook can also be installed over strap at any location for adjustable anchoring.
EE
FF
GG
STRAP LINK E-STRAP CONNECTOR
Installation recommendations for “Snap-Loc E-Track Singles” can also be applied to “Snap-Loc Ultimate E-Track” but make sure to
use our 1/4” inch diameter screws (5/16” inch screws will not t). Here are some features of the “Snap-Loc Ultimate E-Track”: 100%
Made in USA! Horizontal and Vertical slots reduce wear and tear on straps. Faster, Safer and Easier to install with optimal 32” length.
Fits more applications with less cutting and less waste. Lines up with 16” inch on center stud walls. No extra drilling with 3x more
screw holes. Industrial grade 12-gauge USA galvanized steel for interior and exterior use. Fits all industry standard logistic E-Track
accessories and has a 4,400 lb. Break Strength (1,467 lb. WLL). Patent Pending.