Manualshelf

Full Product Manual

ManualsBrandsSNAP-LOC ManualsHardwareE-Track Single Strap Anchor in Black with Self-Drilling Screws (4-Pack)
1234
“SNAP-LOC E-TRACK SINGLES” INSTALLATION WITH WELDING
O. Chose locations for installing “Snap-Loc E-Track Singles” that are not too close to gas lines, electrical or other hazards.
P. W e l d a l l t h e w a y a r o u n d o n b o t h s i d e s a s s h o w n t o a c h i e v e f u l l w o r k i n g l o a d l i m i t .
HOW TO USE
CONNECTING E-STRAPS AND ACCESSORIES TO “SNAP-LOC E-TRACK SINGLES”
All Snap-Loc items are engineered to coordinate with industry standard E-Track and E-Track accessories.
However, we recommend always using Snap-Loc products with other Snap-Loc products for a guaranteed t.
Q. Pull back on the E-Fitting leaver and insert into the “Snap-Loc E-Track Single” as shown.
R. Insert other end of E-Fitting fully into the “Snap-Loc E-Track Single” as shown.
S. Release leaver and jiggle until securely clicked in place.
T. To re mo ve p u l l b a ck le v e r o n E - Fi t t in g an d d i s en g age .
E-STRAP WITH CAM
Z. Push down on Cam buckle lever to adjust strap length in and out of Cam until it ts over cargo.
AA. Connect both ends of strap securely to the “Snap-Loc E-Track Single” (reference Connecting E-Straps and Accessories to
“Snap-Loc E-Track Singles”).
BB. After connected to the “Snap-Loc E-Track Single” pull on loose loop end of strap until rmly snug against cargo.
CC. Use Hook & Loop fastener (a.k.a. Velcro) to secure excess end of strap to keep it from getting caught on wheels and other
objects especially when in motion.
DD. To loosen strap push down on Cam buckle lever and pull on strap until loose.
E-STRAP WITH RATCHET
U. Feed end of strap through Ratchet as shown and pull through until loosely snug around cargo.
V. Connect both ends of strap securely to the “Snap-Loc E-Track Single” (reference Connecting E-Straps and Accessories to
“Snap-Loc E-Track Singles”).
W. Begin moving ratchet handle up and down until there is a minimum of two full revolutions of strap wrapped around the center
pivot. If less than two full revolutions of strap the ratchet will not hold properly.
X. Use Hook & Loop fastener (a.k.a. Velcro) to secure excess end of strap to keep it from getting caught on wheels and other
objects especially when in motion.
Y. To loosen pull back on the Ratchet release lever, open handle 180 degrees and pull on strap until loose.
AA
BB
CC
DD
V W
X Y
R S
T
P