Full Product Manual

“SNAP-LOC E-TRACK SINGLES” INSTALLATION INTO METAL SHEETING WITH ALLEN SCREWS OR CARRIAGE BOLTS

A. Chose locations for installing “Snap-Loc E-Track Singles” that are not too close to gas lines, electrical or other hazards and mark the

center of screw holes.

B. Drill holes using a 3/8″ inch metal drill bit.

C. If using Snap-Loc 5/16″ inch Allen Screws, use a 3/16″ inch Allen wrench or socket to hold screw from spinning.

D. If using Snap-Loc 5/16″ inch Carriage Bolts, t the screws square neck into the “Snap-Loc E-Track Singles” square holes.

E. Install the washer then the nut with the round edge facing outward and tighten all the way with a 1/2″ inch wrench or socket wrench.

“SNAP-LOC E-TRACK SINGLES” INSTALLATION INTO WOOD FRAMING WITH LAG SCREWS

H. Chose locations for installing “Snap-Loc E-Track Singles” that are not too close to gas lines, electrical or other hazards and mark

the center of screw holes.

I. If using Snap-Loc 5/16″ inch wood Lag Screws, use a 1/8″ inch drill bit to pilot holes the length of the screw.

J. Use a 7/16″ inch socket on a drill to drill screw into wood framing until tight. Do not overtighten.

“SNAP-LOC E-TRACK SINGLES” INSTALLATION INTO THICK METAL WITH DRILL AND TAP

K. Chose locations for installing “Snap-Loc E-Track Singles” that are not too close to gas lines, electrical or other hazards and mark

the center of screw holes.

L. If using Snap-Loc 5/16″ inch Allen Screws, make sure metal is 3/16″ inch or thicker and use a G size drill bit to pilot a hole to the

length of the screw. Using a 5/16-18″ thread count tap, tap the threads into the hole.

M. Use a 3/16″ inch Allen wrench or socket to install screw until tight.

N. If additional holding strength is desired, install washer then the nut with the round edge facing outward and tighten all the way with a

1/2″ inch wrench or socket wrench.

“SNAP-LOC E-TRACK SINGLES” INSTALLATION INTO METAL FRAMING WITH SELF-DRILLING SCREWS

F. Chose locations for installing “Snap-Loc E-Track Singles” that are not too close to gas lines, electrical or other hazards and mark the

center of screw holes.

G. If using Snap-Loc 5/16″ inch Self-Drilling Screws, use a 1/2″ inch socket on a drill to drill screw through metal until tight.

If metal is dicult to drill through use a 1/4″ inch drill bit to pilot hole. Do not overtighten.

A B

F G