Full Product Manual

WARRANTY
If product becomes damaged and is structurally unsafe immediately discontinue use.
For questions or return authorizations please email [e-mail] or call 1-800-798-4521
1. Snap-Loc guarantees our products to be free from defects in material and workmanship for a period of 90 days from date you
received the product.
2. No returns will be accepted without pre-approved authorization.
3. No returns will be accepted more than 30 days after authorization to return has been issued.
4. During the warranty period Snap-Loc will at its own discretion repair, replace parts or replace in whole products found to be defective in
material or workmanship. Installation labor on replacement parts excluded.
5. Pre-approved return shipping will be paid for by Snap-Loc if in the continental United States. Some restrictions apply.
6. Here are some things not covered under warranty; exceeding weight limit, misuse, accident, alteration, improper installation, over
tightening, scratching, chipping, discoloring, minor plastic cracks that don’t aect usability, use in extreme freezing weather or
extreme heat, water submersion, exposure to corrosive chemicals, unauthorized repair and other similar negligence.
7. Snap-Loc will not be liable for direct or indirect consequential damages whatsoever.
8. The literature included with this product has been written for your safety. If you do not accept the terms and conditions herein do not
use this product and return it within 7 days after purchase. By keeping this product you are agreeing to our terms and conditions.
9. This Manual was created June 2019 please check www.snaploc.com for updates thereafter.
V W
X
Z
Y
INSTALLING THE BAR HANDLES AFTER THE HITCH RECEIVER
Until bars are used more they may t a little tight, especially if this is your rst time learning how to
install them. To help installation use a slight twisting or shaking motion until Spring Buttons are clicked
in holes. It is very important to install both sides of the bars evenly at the same time.
V. After installing the Hitch, insert silver Connector Pins into Hitch by pushing Spring Button and sliding Pin in until button clicks into hole.
W. Push Bar: First connect the 2 long curved L-shaped bars together using 1 silver Connector Pin.
X. Next slip the connected U-shaped Push Bar over the 2 Connector Pins in the Hitch and install both ends of Push Bar evenly at the same
time until Spring Buttons click into holes.
Y. Panel Bars: First connect the 2 long curved L-shaped bars together with the 1 fteen-inch extension bar and 2 silver Connector Pins.
Z. Next slip the connected U-shaped Panel Bar over the 2 Connector Pins in the Hitch and install both ends of Panel Bar evenly at the same time
until Spring Buttons click into holes.