Installation Instructions

1. With Spring Buttons facing
down, insert Hitch into Dolly
frame until Spring Buttons
click into place. Both sides
of Hitch forks need to be
installed evenly or they may
get stuck.
Reference the Snap-Loc Dolly System Manual sheet for more information.
For further questions please call 1-800-798-4521 or email [e-mail]
Dolly Bar Assembly
Quick Reference Guide
2. Place the silver Connector
Pins into Hitch until Spring
Buttons click in place.
3. For Push Bar, insert silver
Connector Pin between
curved bars. If a Panel Bar,
add the 15 inch Extension
in the middle.
4. Assemble curved bars over
Connector Pins in the Hitch.
Both sides of bars need to
be installed evenly. Bars will
be a tight fit so a twisting or
shaking motion will assist
assembly until Spring
Buttons are clicked in place.