User Manual

PROPRIETARY
The information contained in this document may be subject to change without notice.
The information contained in this document shall remain the sole exclusive property of s.m.s smart microwave sensors GmbH.
2012-06-07_UserManual_EKTSDG.doc I Page 7 of 15 I June 7, 2012 www.smartmicro.de
4 EKTSDG Handheld Operation
4.1 Controls
4.2 Using EKTSDG
4.2.1 General Remarks
Prepare the settings as described in section 5.2. Maximum distance depends on the
radar sensitivity and the amplitude settings of EKTSDG.
4.2.2 Power Indicator and Charging
When you are using the EKTSDG without a USB connection the power indicator (5)
begins only to blink if the power of the battery is too low. → Connect the EKTSDG
over USB with a PC to charge the accumulator. The charge indicator (3) turns on
when you connect and turns off when the accumulator is fully loaded. If the charge
indicator blinks the accumulator generates a fail and must be changed.
4.2.3 Using Default Preset
The default preset will be executed, until the programmed duration elapses.
1. Align the antenna (6) against the transceiver
2. Press the Power switch (1) for 0.5 seconds
> EKTSDG begins simulating the programmed speed, amplitude and direction
> EKTSDG stops after the programmed duration or after switching off manually
with (1)
4.2.4 Selecting Another Preset
The selected preset will become the new default preset and will be executed, until
the programmed duration elapses:
Figure 2: Controls and Displays
(4) USB Connector
(2) Preset Selector
(1) Power On
(5) Power Indicator
(7) Active Preset
(6) Antennas
(3) Charge Indicator