Instructions / Assembly

NOTE:

a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner while placing the strip in a concave

position. (Angle 90º)

b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner while placing the strip in a concave

position. (Angle 60º)

c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner while placing the strip in a convex

position. (Angle 60º) In the convex position the angle should not reach 90 degrees. See above diagram.

NOTE:

If you need to secure the connector to the

surface, please remove the protective tape from the red

adhesive of the connector carefully, place the connector

in the desired location and press to ensure proper

adhesion to the surface.

Installation (continued)

There are two installation options to choose from:

□ 4A Tape method: Remove the protective tape from the adhesive back of the LED strip carefully. Place the LED strip onto a clean

and dry surface in the desired location, press to ensure proper adhesion to the surface. This method is suitable for indoor installation

and can be used for outdoor installation in conjunction with method 4B.

□ 4B Tape method: Place the LED strip in the desired location. Use the clips (BB) and screws (AA) to secure the LED strip as shown.

Clips (BB) should be placed in open areas of the strip. Do not cover the LED chips.

Installing the LED strip

a. b. c.

LED Chip

Angle 90º Correct lncorrect lncorrectAngle 60º

IMPORTANT:

Before removing the 3M paper backing, it is important to test the LED strip in the space you intend to light.

Once the 3M paper backing is removed and the lighting is fully installed, you cannot reposition or move the LED tape light to

another location. The tape may not stick securely.