Instructions / Assembly

Installation

□ Remove any surface dust from the area where you will be applying the LED strip. A brush (not included) is recommended to

remove any surface dust.

□ Measure the desired space for the LED strip installation to determine if you need to use one or two strips.

Preparing the assembly location

Preparing the LED light strip

NOTE:

Connect the LED strip "A" (B) to the in-line remote and adapter by aligning the arrows on the connector

leading from the remote control to the connector on the LED strip "A" (B). If you require two LED strips, then connect

the LED strip "B" (C) to the end of the LED strip "A" (A) by aligning at the arrows on the connectors. Please make sure

the connectors are securely fastened all the way on both sides.

NOTE:

If you are only using one LED strip for your installation please use LED strip "B" (C) that does not have a

connector at the end of the stip.

WARNING:

If you are only using LED strip "A" (B), you must connect the end cap to the connector at the end of the

strip. Failure to use end cap at the end of the strip may cause permanent damage to the strip.

NOTE:

You can link together a maximum of 2 x 3.66 m / 12 ft strips using the same adapter for a total of 7.32 m /

24 ft.

correct

B C