User Guide
Programming
TV Programming
3. Programming must be done for both your TV and cable box separately. Locate and underline the
Device Codes for your TV and for your cable box, listed at the end of this guide. There may be one or
many codes listed for any particular TV or cable box. For cable boxes, first search by cable provider
name. If you do not locate your cable provider name on our list, search instead by the cable box's
manufacturer name, which is usually marked somewhere on the cable box. If you do not use a cable
box disregard Programming For Cable Box section.
NOTE: If your device or devices is/are not listed, skip ahead to the Manual Code Search section.
However, if your TV or cable box was manufactured prior to, or around the year 2000, please check
our Full Code List on our website, www.smpltec.com/oneclick before you try the manual code search.
** If the Volume does not change, start again at Step 1 entering the next TV code listed (and so on).
If none of the codes work proceed to the Manual Code Search / TV section.
* Entering codes: For example, to input code 273, follow this procedure.
NOTE: to enter a zero, simply do not press the button for that digit.
Press and release the 100 button two times.
Press and release the 100button seven times.
Press and release the 1 button three times.
STEP 1
STEP 4
STEP 3
STEP 2
With the TV on, press
and hold A until the
Indicator Light turns
solid green, then
release A
Point the remote at the
TV and press the Volume
up button to test the code.
If the volume changes
proceed to Cable Box
programming.**
Press &
UHOHDVH¶$·
While the Indicator
Light is green, enter the
ÀUVW79FRGHQXPEHU
listed using the 100,
10 & 1 buttons*
A
100
B
10
C
1
UHOHDVH¶$·
DQGKROG$XQWLOWKH
UHOHDVH$
ÀQDOL]HLWV