Owner's Manual

3 Assembly and Set-Up
1. To release the folding mechanism, place
the scooter on the ground, push the release
lever down to unfold the scooter.
2.Using the 5 mm Allen Wrench
loosen the handlebar clamp.
3. Insert the handlebar with the throttle
facing the rider.
4. Using the 5mm Allen Wrench
tighten the hanclebar clamp.
5. To adjust the height of the handlebar,
open the quick-release lever and slide the
T-bar to the desired position and resecure
the quick-release lever to lock into place.
6.The tension of the quick-release lever
can be adjusted by manually tightening
or loosening the Allen bolt. Be careful
not to overtighten.
You should always be able to open and
close the quick-release lever by hand
and the T-bar should slide freely when
the quick-release is open.
05 06