User`s manual

Page 9
• Connect the RF receiver to an available USB port on your
computer. This may have been done when batteries are being
charged.
• The radio frequency (RF) codes are factory preset for your
convenience; the keyboard and mouse should be functional at this
point.
• If for any reason the keyboard do not function correctly, i.e. no
cursor movements, there may be other wireless devices in the
vicinity operating in the same radio frequency channel. They
keyboard and mouse can be easily reset to another channel.
• To connect the mouse to your system, press the connect button
located at the bottom of the RF receiver (1) while it’s connected to
the computer’s USB port, and press the connect button located at
the bottom of the mouse (2). This will reset the mouse and the RF
receiver to a different channel to avoid interference.
• To connect the keyboard to your system, press the connect button
located at the bottom of the RF receiver (1) while it’s connected
to the computer’s USB port, and press the connect button located
at the upper right-hand corner of the keyboard (3). This will reset
the keyboard and the RF receiver to a different channel to avoid
interference.
• This step can be repeated when needed.