User's Manual

Pairing the Mouse to the Receiver Dongle
• Your mouse is pre-paired with the receiver dongle at our factory for your
convenience, and it’s now ready to work. First, turn on the mouse power by
moving the power switch located at the bottom of the mouse to “on” position.
When the power is switched on, the green LED lights up for about 2 seconds
to indicate the mouse is powered on.
• Plug the USB receiver dongle to the computer’s USB port if it’s not already
plugged in. The mouse is functional and ready to work. Note: if your mouse
comes with the matching keyboard as a combo set, there is only one receiver
dongle shared by both keyboard and mouse. If the mouse is part of a 3-
device combo set with keyboard and a PowerPoint presenter, the dongle is
shared among all 3 devices.
• The radio frequency (RF) codes of the mouse must be paired up with the
receiver before the mouse can be used. This step has been done for you at
our factory. However, if anytime you need to reconnect your mouse to the
receiver dongle, please perform the following steps to establish the link:
o Make sure the mouse is powered on.
o Plug the mini USB connector of the USB adapter (included in the box) to
the mini USB port on the mouse.
o Connect the RF USB receiver dongle to the USB adapter while the
adapter is plugged in to the mouse; the RF indicator light on the mouse
turns green. Leave it connected for approximately 3 seconds until the RF
indicator light turns off; this is the indication that the RF is successfully
connected. Caution: the auto-pairing is taking place while the mouse and
the receiver are physically connected; do not remove the receiver dongle
prematurely while the LED is on.