Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Extended Top (Part # 937xx)
2004-2006 Jeep Unlimited
Step 3: The sides of the brief can be attached two different ways. If your vehicle is equipped with the
factory door surrounds slide the plastic channel on the side of the brief into the channel on top
of the door surround.
If your vehicle does not have the door surrounds wrap the flap on the side of the brief around the
crossbar and attach to Velcro on side of brief.
Step 4: Locate the long center strap. Run the strap back around the center roll bar and back forward toward
the windshield frame. Put strap through footman loop on windshield frame and secure to buckle.
(Fig E)
Step 5: Locate the two side straps near the center roll bar. Wrap the straps around the roll bar and
attach to buckle. (Fig F)
(Fig E) (Fig F)
Step 6: Locate the rear corner straps. Wrap the strap around the roll bar or seat belt harness top bolt.
(Fig G) Feed the end up through the buckle and pull tight. Note: Be sure strap does not
interfere with the operation of the seat belt.
Step 7: Go back and check that all straps are secured tightly. Installation is now complete.
Note: After a few days the material may relax so you’ll need to go back and secure straps again.