Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Cage Kit
07-11 JK Unlimited (4-Dr)
Part # 76902
(Fig 26) (Fig 27) (Fig 28)
(Fig 29) (Fig 30) (Fig 31)
Step 23: Secure both main plates on the center sport bar with included Allen head hardware. (Fig 31) Do not
tighten completely at this time.
Step 24: Reinstall the foam and padding on the roll bar brace bars above the doors. You will also need to
trim these in order to clear the front top bar of the front main plate. (Fig 32)
Step 25: Reinstall the sound bar. It will sit a little lower now. You can trim the lip edge on the inside of the
large diameter hole that the “T” top screw goes into.
Step 26: OPTIONAL: The front corner molded pieces previously removed can be reinstalled with some
careful trimming or left off. If trimming use the installed vertical front uprights in order
to use as a guide on where to trim. ( Fig 33, 34)
Step 27: SOFT TOPS: If you are using your door surrounds you will need to trim a portion of the front
clamp on both sides in order to clear the front top cage bar. This can easily be done with a hack-
saw. Hold the surround up into position and mark the area that needs to be cut off and then
carefully trim it.