Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Cage Kit
07-11 JK Unlimited (4-Dr)
Part # 76902
Step 19: Making sure the rear is centered mark the holes. Then remove the main plate and center punch
the holes and drill out to 1/2” (Fig 20, 21)
(Fig 20) (Fig 21) (Fig 22)
Step 20: Set the rear main plate on top of the front main plate on the center sport bar. (Fig 22)
Step 21: Mark the rear sport cover where the rear of the rear top plate would mount. Remove the rear plate
and carefully make a slot in the cover so the clamps can go through. You will also need to notch
the foam with a sharp razor knife in order for the bracket to sit flush. (Fig 23, 24, 25)
(Fig 23) (Fig 24) (Fig 25)
Step 22: The rear of the rear main plate mounts into factory holes. Once padding is slotted and foam is
notched reinstall the rear main plate by installing the included tube spacers and hex-bolts. Do not
tighten hardware completely. (Fig 26, 27, 28, 29, 30)