Installation Manual

ManualsBrandsSmittybilt ManualsOtherSmittybilt 76902 SRC Cage Kit for Jeep JK 4-Door - 7 Piece

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Cage Kit

07-11 JK Unlimited (4-Dr)

Part # 76902

Parts Included Qty

Driver Front Upright 1

Pass Side Drill Template (7289) 1

Passenger Front Upright 1

Drvr Side Drill Template (7288) 1

Dash Bar 1

Tube Spacers 2

Front Top Cross Bar 1

Sport Bar Clamps 4

Front Top Main Plate 1

Hardware Bag (90-6806) 1

Rear Top Main Plate 1

Step 1: If equipped fold down your softop or remove your hardtop.

Step 2: Remove your sun visors and front top corner plastic molded piece. (Fig 1, 2, 3)

(Fig 1) (Fig 2) (Fig 3)

Step 3: Unzip the sport bar padding covers on the tubes above each door. Remove the hard foam core

underneath. Use care when doing so.

Step 4: Remove the vehicles doors and the top inside hinge. Take off both side panels from the side of your

front dash. (Fig 4)

Step 5: Install the passenger side drill template (7289) by attaching it to the top inner hinge location on the

vehicle using the OEM hardware. (Fig 8)

Step 6: Center punch the two holes, using the drill template as a guide. (Fig 9)

Always use caution when drilling.

Please read instructions entirely before installing this product. Drilling is required to install this part.

Summary of content (8 pages)

PAGE 1
Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 WWW.SMITTYBILT.COM Please read instructions entirely before installing this product. Drilling is required to install this part.
PAGE 2
WWW.SMITTYBILT.COM (Fig 4) Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 (Fig 5) (Fig 7) (Fig 6) (Fig 8) Step 7: Remove the drill template. Drill the two marked hole out to 7/16”. Step 8: Install the passenger side vertical front upright; by first sliding the lower corner in first rotating inward slightly and then pushing up horizontally. (Fig 5,6) Step 9: Line the top of the upright with the two holes near the windshield visor mount.
PAGE 3
Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 WWW.SMITTYBILT.COM Step 10: Repeat steps 5-9 for the opposite side of the vehicle. Re-install the inner top OEM door hinges. Step 11: Install the passenger side vertical front upright by securing the top bolts and two button head bolts through the door jam area snug. (Fig 7, 10, 11) (Fig 9) (Fig 10) (Fig 11) Step 12: Set dash bar across dash. Loosely attach it to the passenger side.
PAGE 4
Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 WWW.SMITTYBILT.COM (Fig 15) (Fig 16) Step 15: Install the top front bar (The bend points towards the rear and up) Slide the ends of the bar through the slots you made in the cover. It may be easier to do this at a slight angle first. Move bar forward parallel with the windshield frame. Position it as far forwards as you can. Step 16: Loosely attach front clamp brackets with the included socket cap bolts.
PAGE 5
WWW.SMITTYBILT.COM Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 Step 19: Making sure the rear is centered mark the holes. Then remove the main plate and center punch the holes and drill out to 1/2” (Fig 20, 21) (Fig 20) (Fig 21) (Fig 22) Step 20: Set the rear main plate on top of the front main plate on the center sport bar. (Fig 22) Step 21: Mark the rear sport cover where the rear of the rear top plate would mount.
PAGE 6
Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 WWW.SMITTYBILT.COM (Fig 26) (Fig 27) (Fig 28) (Fig 29) (Fig 30) (Fig 31) Step 23: Secure both main plates on the center sport bar with included Allen head hardware. (Fig 31) Do not tighten completely at this time. Step 24: Reinstall the foam and padding on the roll bar brace bars above the doors. You will also need to trim these in order to clear the front top bar of the front main plate.
PAGE 7
WWW.SMITTYBILT.COM (Fig 32) Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 (Fig 33) (Fig 34) Step 28: Go back and tighten all hardware completely. Installation is now complete.
PAGE 8
WWW.SMITTYBILT.COM Installation Instructions Cage Kit 07-11 JK Unlimited (4-Dr) Part # 76902 Limited Warranties Smittybilt’s products are covered under the following limited warranties only. Note that the duration of the limited warranty differs according to the material and finish of the product purchased. Subject to the duration and conditions of the limited warranty stated below, Smittybilt warrants to the original retail purchaser that its products are free from defects in material and workmanship.