Installation Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Revised 9.28.11
Installation Instructions:
(Part # SB76900)
1997-2006 Jeep TJ
SRC 6-Piece Roll Cage Kit
Step 20: Tighten the OE side support bars to windshield hardware. Clamp the A-pillar
mounts (94-7620 Drvr and 94-7624 Pass) to the OE side support bars. Secure to the side
support bars using the (90-4344) clamp halves, and (8 per side) 5/16” X 7/8” bolts. Leave
hardware loose and slide the clamps as far forward as possible.
Step 21: Line up the holes in the dash with the holes in the lower A-pillar mounting plates.
Secure the lower A-Pillar mounting plates to the dash using the (3 per side) provided nut
plates (90-7628) and (3 per side) 5/16” X 1” button head bolts.
NOTE: Due to variances in the vehicles from the factory, these holes may need to be
opened up.
Step 22: Install the dash bar (94-8211) by rotating up and forward as shown above. Secure
the dash bar to the A-Pillar mounts using the supplied (2 per side) 5/16” X 1 1/4” bolts.
Step 23: Torque all OE hardware according to manufacturers specifications or the supplied
hardware according to the torque chart on page 9.
5/16” X 1 1/4” Bolt
94-8211
Dash Bar
A-Pillar Mounts
94-7620 Drvr and
94-7624 Pass
5/16” X 1”
Button
Head Bolt
90-7628
Nut Plate
90-4344
Clamp
Halves
(8) 5/16” X 7/8” Bolt
A-Pillar Mounts
94-7620 Drvr and
94-7624 Pass
Side
Support
Bar