Installation Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Revised 9.28.11
Installation Instructions:
(Part # SB76900)
1997-2006 Jeep TJ
SRC 6-Piece Roll Cage Kit
Step 12: Install the rear bar (94-8220) to the rear down bars of the OE roll bar. Secure to
the OE rear down bars using the (90-4407) large clamp halves, and (8 per side) 5/16” X 1”
bolts. The rear bar (94-8220) should be positioned at the mid point of the bend in the OE
rear down bars.
NOTE: Due to the fact that the OE cages vary in width, an 1” to an 1 1/2” from the
factory, the rear bar was intentionally built small. You will need to pull the sides of the OE
cage together using a ratchet strap to achieve proper fitment of the new rear bar. Also the
bolts that retain the rear of the OE cage to the floor may need to be loosened.
Step 13: Install the rear cross bars (94-8216 Drvr and 94-8218 Pass) to the OE main cage.
Secure to the OE rear down bars using the (90-4407) large clamp halves, and (8 per side)
5/16” X 1” bolts. Secure the main cage support mounts using the (2 per side ) supplied
5/16” X 1 1/4” bolts. NOTE: They will need to be slid in from the center out.
94-8220
Rear Bar
90-4407 Large
Clamp Halves
(8) 5/16” X
1” Bolts
OE Cage Rear
Down Bars
NOTE: Rear Bar Location on Mid
Point of Bend in OE Down Bar
Rear Cross
Bar 94-8216
Drvr and
94-8218 Pass
94-4408 Main Support Cage Mount
90-4407 Clamp Halves
(2) 5/16” X 1
1/4” Bolts
(8) 5/16” X 1” Bolts
(8) 5/16”
X 1”
Bolts
OE Cage Rear
Down Bar
90-4407 Large
Clamp Halves