Installation Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Revised 7.12.11
Installation Instructions:
(Part # SB76881)
2007-2010 Jeep JK 2Door
XRC Rear Armor Corner Guard Kit
Step 16: Install the inner fender liner tabs (93-7054) to the (2) rear bolts (2nd up from the
bottom and the 4th up from the bottom). Fig. D.
Step 17: Install the inner fender liner (93-4324 drvr and 93-4325 pass) into the armor using
the supplied plastic retainers. Start in the middle and work your way to the outside edge.
Fig. E.
Step 18:
Reinstall the OE tail lights to the tail light bezels on the armor fenders using the
previously removed OE hardware.
Step 19: Repeat the previous steps on the remaining side of the vehicle.
Step 20:
Reinstall the previously removed rear bumper using the previously removed hard-
ware. Torque according to manufacturers specifications.
Step 21: If you are reinstalling the license plate, route the wiring harness through the armor
fender and reconnect the light wiring clip. Install the license plate box to the armor fender
using the previously removed OE hardware.
(Fig E)
Inner Fender Liner
90-4324 drvr and 90-
4325 pass
90-7054
Liner
Tab
(7) Plastic
Retainers
Inner Fender Liner
Attachment Points
3/8” X 1” SS
Bolt