User Guide

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Carbine Front Bumper
Part# 76744
07-16 JK 2 and 4 Door
Step 6: Install the fairlead bracket and inner support bracket (Fig E, F) with the included 10 x
35mm bolt, washer, and locknut. The inners support bracket will line up with some of the top winch
mount holes. Note: using the inner support bracket increases the thickness of the winch mount
plate, some winches may require longer bolts when installed. (Do not fully tighten until winch is
installed)
Step 7: Note: May require two people. Raise the bumper up into place and align the studs
on the bumper with the holes on the frame. Secure using the included 12mm hardware. (Fig G)
(In some circumstances the other holes may also need to be drilled out to ½’ due to variances)
Step 8: Once bumper is secured, using the 4 holes along the lower cross frame as a guide using
a 7/16” drill bit. Secure using the included 10 x 25mm hardware. (Fig H)
Step 9: Reconnect the fog light wiring harness to lights. Note: OE wiring may need to be
extended
Step 10: If installing front license plate to fairlead mount, use included 6mm hardware.
(The spacer between the back of license plate and front of mount/bumper)
Step 11: Installation is now complete. (Fig J)