Installation Manual

TIRE CARRIER INSTALLATION INSTRUCTIONS
10. Insert Nylon Washer and install the Tire Carrier to Bumper. Once the Tire Carrier is assembled, close it and secure
it with the already installed (2) 3/8"-24 x 1" Hex Head Bolt, (4) 3/8" Flat Washers, and (2) 3/8" Lock Nuts (Figure 7
& 8). Tighten hardware at this time.
11. Install the Circle Clip to the top of the Post on the Bumper. Once installed, use a grease gun to lubricate the pivot.
Figure 8
Figure 7
Nylon
Washe
r
Circle Clip
12. Locate Post, (1) 7/8"-14 x 2 1/2" Hex Head Bolt, (2) 7/8" Flat Washers, and (1) 7/8" Lock Nut. Insert Post into Tire
Carrier and secure it with hardware listed in this step (Figure 9). Tighten hardware at this time.
“Post”
7/8”-14 x 2 1/2” Hex Head Bolt
7/8” Flat Washers
7/8” Lock Nut
Figure 9
Page 4 of 5