Installation Manual

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
TOOLS
REQUIRED
- 4mm Wrench
WWW.SMITTYBILT.COM
INCLUDED COMPONENTS
1 – Grille (1 piece)
12 – Metal Brackets
12 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS
1. Inspect product and check components with items listed above.
2. Pop Hood, remove plastic shroud at the top and set fasteners aside.
3. Optional: Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
4. Position the Grille onto grille shell cavity (Figure 2).
5. Mark locations for drilling on the shell under the screws. Then drill holes on those locations.
6. Attach the Grille to the shell by inserting the screws through the shell; secure them with Metal Brackets and
Flange Nuts provided (Figure 3).
7. Reinstall the plastic shroud with the fasteners removed in Step 2.
Figure 1 – Included Hardware
Figure 3 – Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Figure 2
–
Front View of positioning Grille
Installation Instructions
M1 Wire Mesh Grille
(Part #615850)
07-on Jeep Wrangler
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
It is recommended to have this part installed by an experienced shop/mechanic.