Installation Manual

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
TOOLS REQUIRED
- Phillips Screwdriver
- 4mm Wrench
WWW.SMITTYBILT.COM
INCLUDED COMPONENTS
1 – Grille (1 piece)
10– 60°L Brackets
4– 19*50mm Metal Bracket
2– 13*30mm Metal Bracket
4– 36mm Tube
10 – Phillips Screws
26 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS
1. Inspect product and check components with items listed above.
2. Pop Hood, remove plastic shroud at the top and set fasteners aside.
3. Optional: Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
4. Attach the Metal Bracket to screws on the top of the grille, secure them with flange nuts. Remark: Attach the
Tube on the under of the 19*50 Metal Bracket .（Figure 4)
5. Attach the 60° L Brackets to other screws of the grille, secure them with flange nuts.
6. Position the Grille onto grille shell cavity (Figure 2).
7. Mark locations for drilling on the shell through the holes of L Brackets. Then drill holes on those locations.
8. Attach the Grille to the shell by inserting the screws through the tabs of L Brackets and holes on the shell;
secure them with Flange Nuts provided (Figure 3).
9. Reinstall the plastic shroud with the fasteners removed in Step 2.
Figure 1 – Included Hardware
Figure 3 – Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Figure 2
–
Front View of positioning Grille
Figur
e 4
Installation Instructions
M1 Wire Mesh Grille
(Part #615802)
10-on Dodge Ram 2500/3500
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
It is recommended to have this part installed by an experienced shop/mechanic.