Installation Manual

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Standard Bucket Front Seat

(Part # 448xx)

1955-1976 CJ

WWW.SMITTYBILT.COM

Included components: Required Tools:

(1) Seat Back rest Crescent Wrench

(1) Seat Cushion Socket Set

(4) Hex Bolt M10 x 20 Ratchet

(4) Washers

Replacement Seat Assembly

1. Unwrap the side cushion trim in order to

access the bolts as shown in Fig 1.

2. Position brackets of back rest through the

slots of the cushion trim as shown in Fig 2.

3. Securely tighten the 4 bolts through the holes

of the back rest bracket to cushion frame as

shown in Fig 3.

4. Carefully wrap the side cushion trim back

over the back rest bracket and hook the trim

to the plate underneath the cushion frame as

shown in Fig 4.

Replacement Seat Installation

5. Remove old seat from riser by removing 4 bolts.

Save these bolts as they will be reused later.

PAGE 1
Installation Instructions WWW.SMITTYBILT.COM Included components: (1) Seat Back rest (1) Seat Cushion (4) Hex Bolt M10 x 20 (4) Washers Standard Bucket Front Seat (Part # 448xx) 1955-1976 CJ Required Tools: Crescent Wrench Socket Set Ratchet Replacement Seat Assembly 1. Unwrap the side cushion trim in order to access the bolts as shown in Fig 1. 2. Position brackets of back rest through the slots of the cushion trim as shown in Fig 2. 3.
PAGE 2
Installation Instructions WWW.SMITTYBILT.COM Standard Bucket Front Seat (Part # 448xx) 1955-1976 CJ 6. Remove sliders from old seats by removing 4 bolts. Save these bolts as they will be reused later. NOTE: To access the rear 2 bolts push slider arm down and move slider forward. 7. Place sliders onto new seats. Reuse spacers from The old seat to align the slider. 8. Fasten slider to the new seat using the 4 bolts saved from step 5 9.