Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Winch Quick Connect Kit
Part # 35220 (8’)
Part # 35210 (24’
)
Step 10: Insert switch into base. (Make sure it has adequate room to rotate) Fig J
Step 11: Remove the bottom nut from one side on bottom of the switch and connect the 22ft red
(+) cable that has the quick disconnect on the end. (Fig K, L)
Step 12: Remove the bottom nut on the other side and secure the 2ft (+) cable. The opposite end
runs to your battery.
Note: Proceed with steps 4-7 above to complete installation.
Remove switch from base when not in use and keep in safe location. Do not drive vehicle
with switch in base.
(Fig J) (Fig K) (Fig L)
Related Smittybilt Products
Winches Black Box (#2805) Winch Cradle (#2811)