Installation Manual

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Compton, CA 90220

Revised 1.22.09

Installation Instructions:

Winch Plate (Part# SB2802)

87-06 Jeep Wranglers

STEP 1: Remove the front plastic frame/stabilizer bar cover. (Fig A)

NOTE: The stabilizer cover will not be re-used.

STEP 2: Remove front bumper hardware and tow hooks (if equipped). (Fig B)

STEP 3: Remove the front (only) stabilizer mounting bolt. (Fig B) When mounting winch

plate (92-5570) plate you will use the included 10 x 50mm bolts.

(Fig A) (Fig B)

Installation:

NOTE: Carefully read entire instructions thoroughly before attempting to assemble and/or

install this product. These steps are in conjunction with vehicles with the O.E.M. front

bumper. Similar steps can be used with other after-market bumpers.

92-5570 Winch Plate 1 90-2014 Winch Plate Spacer 2

½”-13 x 1 ½ “ bolt 4

10 x 25 mm bolt (For Fairlead) 2

½” lock washer 4

10 mm lock washer 4

½” flat washer 4

10 mm flat washer 2

12 mm x 40 mm bolt 2

10 x 50 mm bolt 2

12mm flat washer 2

10 mm lock nut 2

12mm lock washer 2

Remove front

stabilizer cover.

Remove top

bumper bolts

and front

stabilizer

mounting bolt.

PAGE 1
Revised 1.22.09 Installation Instructions: Winch Plate (Part# SB2802) 87-06 Jeep Wranglers NOTE: Carefully read entire instructions thoroughly before attempting to assemble and/or install this product. These steps are in conjunction with vehicles with the O.E.M. front bumper. Similar steps can be used with other after-market bumpers.
PAGE 2
Revised 1.22.09 Installation Instructions: Winch Plate (Part# SB2802) 87-06 Jeep Wranglers STEP 4: Install winch plate using the supplied hardware. (TJ) 4- ½ x 1 ½ bolts (Torque to 75 ft. lbs), 2- 10 x 50mm bolts, ¼” spacers (Fig C) (YJ) 4- ½ x 1 ½ bolts (Torque to 75 ft. lbs) The large flat washers can be used as spacers. (If needed) Use included ½” bolts to install plate. (TJ) Place spacer (90-2014) between winch plate and stabilizer bracket.