Installation Manual

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Part # 2784
Awning
Rev153
Parts Included Qty
Parts Included Qty
Awning 1
Flat Washer (U-Bolt) 4
“L” Bracket 2
Nylock Nut ( U-Bolt) 4
Stake with Cord 2
6mm x 1” Bolt/Nut 10
“U” Bolt 2
NOTE: The “L” brackets are located inside the awning cover. (At the ends). Once unpacked remove the
protective covers at each end of the main rail (Fig A)
The Smittybilt Awning is designed to be mounted in several differ ways depending on the type of
equipment your vehicle has. You may need to purchase your own hardware on some set-ups.
Directly to a roof rack basket/cage
Step 1: Slide the bolt (head) into the channels on the back of the awning. (Fig B)
Step 2: With assistance hold the awing up to your basket lining up the previously installed bolts to
a flat service on your basket. (Note: it is recommended to have the bolts as far apart as possible)
Mark the basket where the bolts lineup. (Fig C, D) Set Awning to the side for now.
(Fig A) (Fig B)
Please read instructions entirely before installing this product.

Summary of content (8 pages)