User Manual

4
Mounting Extrusion - Attachment Instructions
1. Remove mounting extrusion from the carton (cut as per Diagram 1 if you intend opening the
rooftop tent off the rear of your vehicle.)
2. Place the tent on its side on the ground onto a clean surface.
3. Using the supplied 6mm bolts and washers, slide your hand in between the inside of the base
and the mattress and insert the bolts into the pre-drilled holes. See Diagram 2.
4. Place the mounting extrusion into position over the bolts.
5. Slide the 6mm nuts into the mounting extrusions and tighten the bolts from inside the tent. See
Diagram 2.
6. Near the outside edges of the mounting extrusion you will find holes for the self drilling screws
supplied. Use the self drilling screws and washers to attach the outside edge of the mounting
extrusion to the base of the tent through the end pre-drilled holes.
7. Mount the Ladder brackets to the ladder using the supplied 6mm x 20mm bolts, washer, plastic
washer, spring washer and nut. See Figure 1.
8. Mount the ladder to the base of the tent using 4 x 6mm x 40mm bolts. Bolt each ladd er bracket
to the base of the tent through the pre-drilled holes. See Figure 2. If using ladder extension
simply slide onto ladder and secure with lock pins ( Fig 2A)
Diagram 2