Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
SMART COVER
(Truck Bed Cover)
Parts Included Qty
3-Fold Cover 1
Cargo Net 1
Smart Cover
Step 1: Carefully remove the cover from the box.
Step 2: The “Smart Cover” is already assembled and ready to set on vehicle. Using assistance place the
cover on the bed of the vehicle. Note: The end with the buckles goes towards the cab of the vehicle.
Step 3: With the cover folded out completely adjust the cover on the bed of the vehicle so it’s straight and
and even on each side.
Step 4: Once the optimal position is obtained fold the cover forward towards the front of the cab. (Fig A)
Step 5: Secure the front (one per side) cam-action clamps by first pulling the clamp down from its locking
position on the cross bar, then rotate the clamp or down in order for it to fit tight when clamped
down. (Fig B)
(Fig A) (Fig B)
Step 6: Slide the clamp towards the side rail of the vehicle (Fig C) then push down the lever towards the
the side of the vehicle to lock into place. (Fig D, E) Note: Make sure clamp is securing to vehicle
bed rail and not a plastic bed cap or other accessory.
Note: Read instructions entirely before attempting to install this product.
Once the optimal position is
obtained fold the cover
forward towards the front of
the cab.