Operator's Manual

66
RefeRences and TRoubleshooTing
RefeRences and
TRoubleshooTing
Note: Refer to the instructions for use for each accessory before proceeding with cleaning.
For optimal efficiency, it is recommended best practice to clean first and then disinfect. All disinfectants
require pre-cleaning, except for disinfectant cleaners that are tested to disinfect in the presence of 5% of
organic matter.
1. Inspect the Downstream Occlusion (DSO) seal for damage or wear to the rubber material during
cleaning and at each preventative maintenance service. DSO seals that show signs of cracking or
abrasion(s) should be returned to a Smiths Medical Service Center for replacement of the DSO seal, sensor,
and bezel.
If the DSO seal does not have cracking and/or abrasion(s), continue with the following steps to clean and
disinfect the pump and accessories, unless otherwise specified in the instructions for use for an accessory:
2. Clean the pump and its accessories using a mild detergent soap solution to remove residuals or
contaminated material. Apply solution to a soft, lint-free cloth and then wipe the pump or accessory. Do
not allow the solution to soak into the pump or accessory.
3. Disinfect the pump and its accessories by applying a disinfecting solution (listed below) according
to the disinfecting product label instructions. If using a liquid or spray, apply solution to a soft, lint-
free cloth and then wipe the pump or accessory. Follow the disinfectant manufacturer’s recommendations
for disinfectant contact times. Do not allow the solution to soak into the pump or accessory.
Acceptable disinfecting solutions for the CADD®-Solis pump and its accessories are listed below.
Note: For the CADD®-Solis LockBox, use only the Sani-Cloth® Bleach product listed below as other
products may affect the transparency of the lockbox.
Product Manufacturer
EPA
Registration
Number
Active Ingredient(s)
Contact/
Kill Time
CaviWipes™
(Do not use with
CADD®-Solis LockBox)
Metrex 46781-8 17.2% Isopropanol 3 minutes
Sani-Cloth® Super
(Do not use with
CADD®-Solis LockbBox)
PDI 9480-4 Dimethyl Benzyl
Ammonium Chloride,
Dimethyl Ethyl Benzyl
Ammonium Chloride
2 minutes
Sani-Cloth® Bleach PDI 9480-8 0.60% Sodium Hypochlorite 4 minutes
4. Allow the pump and accessories to dry completely before use.
Scroll Ranges
Continuous Rate Scroll Ranges
Units Starting Value Increment Maximum
Milliliters 0 0.1 100
Milligrams only 10% of
concentration
Values between 0.01 and 0.5: 0.01 Concentration x 100
Micrograms
only
10% of
concentration
Values between 0.1 and 0.5: 0.1 Concentration x 100
Milligrams and
Micrograms
10% of
concentration
Values between 0.5 and 100: 0.1 Concentration x 100
Values between 100 and 1000: 1.0
Values greater than 1000: 10.0