Operator's Manual

Programming and oPeration

Programming

and oPeration

Wireless Status

This screen is available only when a CADD®-Solis Communication Module is

installed. This report is used by network or systems adminstrators to view the

current status of the pump wireless module and its connectivity to the

wireless network

If the Communication Module is incompatible with the wireless network

conﬁguration programmed in the pump, the status reported on the screen

will be “Incompatible Conﬁguration”.

Note: For information about how to turn wireless on/oﬀ and viewing basic

wireless status, see page 38.

To view wireless status:

1. From the Home screen, select Reports.

2. From the Reports menu, press U or D to choose Wireless Status and

press S.

Wireless Settings

This screen is available only when a CADD®-Solis Communication Module is

installed. This report is used by network or systems adminstrators to view the

conﬁguration settings for the communication module.

Notes:

•

For information about how to turn wireless on/oﬀ and viewing basic wireless

status, see page 38.

•

Wireless settings can be modiﬁed only by network administrators using

the CADD®-Solis Network Setup Utility software. For more information,

administrators should consult the documentation included with this

software.

To view wireless settings:

1. From the Home screen, select Reports.

2. From the Reports menu, press U or D to choose Wireless Settings and

press S.

Device Information

The device information screen allows you to view the pump serial number,

asset ID, software (package number) and hardware version numbers, and

the last error code (if one exists). If a CADD®-Solis Communication Module is

installed, the communication module (CM) revision and MAC address is also

shown.

Note: Review your facility’s procedure for handling error codes (see Alarms

and Messages, Alphabetical List on page 58 for more information).

To view device information:

1. From the Home screen, select Reports.

2. From the Reports menu, press U or D to choose Device Information

and press S.