Operator's Manual

Programming and oPeration

Programming

and oPeration

4. Unlock the keypad using the pump key (if allowed) or press U or D to

enter the clinician code (or a higher level code). Press

to advance to

the next digit. Once the code is entered, select Accept Value.

Note: If you enter a code that you believe is correct and receive a wrong

code error, check the screen to see if the clinician code is customized.

If the code was not customized, it was entered incorrectly. Retry. If the

code is customized, use the custom clinician code. If you do not know

this code, contact your PharmGuard® system administrator.

WARNING: To prevent the patient from accessing the clinician bolus

function, do not let the patient know the security codes. Improper

programming could result in serious patient injury or death.

5. Make sure the clinician bolus amount is at the desired value and select

Deliver.

Note: If you enter a value outside the soft limit, a screen appears asking you

to conﬁrm the soft limit override.

6. The screen shows the amount decreasing as the bolus is delivered. You may

stop the bolus at any time by selecting Stop Bolus.

WARNING: Never leave the pump unattended while on the clinician bolus

edit screen. You must deliver the programmed value, or cancel to leave

the screen. Failure to do so could result in serious patient injury or death.

Start New Patient

Each time a new patient is started, it is recorded in the event log. All other delivery related reports are

cleared.

To start a new patient:

1. Stop the pump if it is running.

2. From the Home screen, select Tasks.

3. From the Tasks menu, press U or D until Start New Patient is

highlighted and press S.

4. If your library was setup to use proﬁles by the PharmGuard® system

administrator, the previously selected proﬁle is shown. Proﬁles contain a

grouping of protocols (e.g., proﬁles can be deﬁned for speciﬁc care areas,

etc.). If your desired therapy is contained within the proﬁle shown, select

Yes, otherwise select No. If No is selected, you may press U or D to

highlight the desired proﬁle and press S.

5. The therapies contained within your selected proﬁle are shown.

Press U or D to highlight the desired therapy and press S.