Manual
13
INSPECTING & INITIAL ASSEMBLY CONT’D
• Holding the barrel assembly in one hand and the frame
assembly in the other hand, engage the hinge pin cutouts in
the barrel lug (Figure 10) onto the hinge pivot trunnions inside
the receiver (Figure 11).
• Rotate the barrel on the hinge - upwards at the muzzles - to
close the action (Figure 13). You will feel and hear a detent
when the shotgun is fully closed.
• Place the rear of the fore-end iron against the receiver. Align
the fore-end latch hook into the receiver and carefully rotate
the fore-end up and into place (Figure 14).
• Push the fore-end lever closed - until it is flush with the fore-
end surface to - lock it into place (Figure 15).
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15
LUG
HINGE
PIVOT
HINGE
TRUNNION