Manual

DISASSEMBLY
1. Using a drift punch, depress floorplate catch (4) through hole
in magazine floorplate (5).
2. Slide magazine floorplate (5)
out of magazine tube (1)
while holding floorplate
catch (4) in the magazine
tube (1).
3. Remove floorplate catch (4)
and magazine spring (3) out
through bottom of magazine
tube (1).
4. Turn magazine tube (1)
right side up and remove
magazine follower (2)
through bottom of
magazine tube (1).
MAGAZINE DISASSEMBLY
(1)
(2)
(3)
(4)
(5)
23
FIGURE 17
REASSEMBLY
• With the rear of the slide pointed in a safe direction and the
bottom of the slide turned up, replace the barrel in the slide
so the muzzle is flush with the end of the slide and barrel
lug is turned up (away from the ejection port). Replace the
recoil spring. Be sure the recoil spring is centered and
seated properly.
• Holding the slide and recoil spring firmly in one hand, move
the rear of the slide onto the frame rails. Continue moving
the slide onto the frame until the slide is fully rearward
before allowing the slide to return forward to the closed
position.
FIGURE 14
FIGURE 15
FIGURE 16