Manual
TARGETING AND
SIGHT ADJUSTMENT
•Your pistol has been targeted at the factory, however should
you wish to further adjust the windage, simply move the sight
in the direction you want the bullet to move on the target.
There are four different front sight heights available from our
product service department.
•To move the rear sight, turn the screw on the right side of the
rear sight. One click (1/4 turn) moves the bullet a little over
1/16” at 25 yards. Turn the sight screw clockwise to move
the point of impact left. Turn the sight screw counter -
clockwise to move the point of impact right. The elevation is
adjusted by changing front sight heights. To change the front
sight, follow the instructions for field stripping and remove
the barrel from the slide assembly, remove the front sight
screw from inside the slide assembly and remove the front
sight. Assembly is in reverse
order. To move the point of
impact up, install a lower front
sight. To move the point of
impact down, install a taller front
sight.
20
UNLOADING
• Lock the slide to the rear by pushing the slide stop lever
upwards while pulling the slide back and allowing it to go
forward slightly to be held rearward by the slide stop lever.
• Look into the chamber and down through the magazine well.
Verify that no ammunition remains in the pistol.
• Pull the slide to the rear and release it or depress the slide
stop lever to allow the slide to move forward.
•Point the muzzle in a safe direction. Make sure your finger is
off the trigger, and the trigger is in the "at rest" or forward
position. Depress the magazine release, and remove the
magazine. With the muzzle still pointing in a safe direction,
and with your finger off the trigger and outside the trigger
guard, grasp the serrated sides of the slide from the rear with
the thumb and fingers, and briskly draw the slide fully
rearward in order to extract any cartridge from the barrel
chamber and clear it from the pistol.
WARNING: Do not obstruct the ejection port
because doing so can interfere with ejection of a
cartridge and thereby creates the risk of exploding
an unchambered cartridge and possible injury.
• Visually check the barrel chamber to be sure it is empty.
• Unload the magazine by holding it with the bullet end of the
cartridge pointing away from you and pressing each cartridge
forward and out of the magazine.
Figure 9