User's Manual

ManualsBrandsSmith-Victor ManualsCopystands & Copylights42" Pro-Duty Copy Stand Kit

Models without Lights: CS36 (402180) 36” Pro-Duty Copy Stand, CS42

(402181) 42” Pro-Duty Copy Stand

Models with LED Lights: CS36K (402182) 36” Pro-Duty Copy Stand Kit,

CS42K (402183) 42” Pro-Duty Copy Stand Kit

Light Kit sold separately: CSLED Kit (402184) LED Copy Light Set (2) with

Adjustable Arms

Copy Stand - Instructions

Thank you for your purchase. The stand

comes in two boxes; one for the baseboard

and one for the upright. Three boxes if you

purchased the Copy Stand with LED Light

Set.

Mounting the upright to the base

Inside the box for the upright is a bag taped

to the upright. Inside the bag is (1) 4mm

Allen tool, (4) 30mm screws. (4) Washers.

And (3) 17mm screws. A 5mm Allen tool is

stored in the top of the upright. (See photo)

Take the (4) 30mm screws and place them

through the holes of the bottom side of the

mounting bracket that is attached to the

baseboard. Slide the upright onto the

screws. Finger tighten then use Allen

wrench to secure the upright to the

baseboard by tightening the screws.

Optional camera platform configuration

For larger cameras, the camera platform

extension can be removed. (See next page

for example) To shorten the camera

platform, simply remove the (3) 69mm

extension mounting screws. Remove the

extension block. Then re-attach the

platform with the (3) included 17mm

screws and washers from the 69mm screws.

Using your copy stand

To use, attach your camera to the platform

using the ¼-20” mounting screw. Do not

overtighten. Be careful to keep the back of

the camera parallel to the baseboard.

Otherwise you may experience distortion or

lack of sharpness on one edge of the image.

Use a bubble level if uncertain.

To move the camera to the position

desired, grasp the quick release handle and

squeeze, move into position, and release.

CS42K Kit fully assembled

Mounting screws attach from

the bottom of baseboard into

holes on the upright. (4) Total.

Camera platform with ¼-20”

camera screw and included

3/8-16” adapter.

Extension Mounting Screws

Quick Release Handle

5mm Allen tool

Summary of content (2 pages)

PAGE 1
Copy Stand - Instructions Models without Lights: CS36 (402180) 36” Pro-Duty Copy Stand, CS42 (402181) 42” Pro-Duty Copy Stand Models with LED Lights: CS36K (402182) 36” Pro-Duty Copy Stand Kit, CS42K (402183) 42” Pro-Duty Copy Stand Kit Light Kit sold separately: CSLED Kit (402184) LED Copy Light Set (2) with Adjustable Arms Thank you for your purchase. The stand comes in two boxes; one for the baseboard and one for the upright. Three boxes if you purchased the Copy Stand with LED Light Set.
PAGE 2
Copy Stand - Instructions For use with larger cameras, the extension block can be removed to shorten the camera platform. (3) 13mm screws are provided for this optional configuration.