Full Product Manual

Page 4
ZL Shut-o Spraying and Locking
1. Direct nozzle away from you and squeeze shut-o
lever to begin spraying.
2. For continuous spraying, squeeze lever and rotate
lock up. (See Figure G).
3. Unlock if needed and release shut-o lever to stop
spraying. (See Figure H)
4. Turn the nozzle tip to adjust the spray pattern.
Figure G
Figure H
OPERATING INSTRUCTIONS
Filling
IMPORTANT: Always make sure the pressure is
released from the tank before  lling or servicing.
1. Pull up on the knob of the pressure release
valve until all the pressure is released from the
tank. (See Figure F.)
Figure F
Pump Clamp Tab
Pump Unlocking And Pressurizing
TO PRESSURIZE: Push down on the handle to depress coil
spring and turn handle 1/4 turn counterclockwise to unlock
handle. Pressurize the sprayer by pumping the handle in a
smooth up and down motion. Push down on the handle
to depress coil spring and turn handle 1/4 turn clockwise,
then allow handle to raise into lock position.
TO UNLOCK PUMP: Turn handle counterclockwise until
4-prong clamp is loose, then rotate clamp counterclockwise
aligning the tabs with the slots in the neck of the tank and
remove the pump.
TO LOCK PUMP: Align clamp tabs with the slots in the neck
of the tank and lower the pump assembly, rotate the 4-tab
clamp clockwise to the stop position and rotate the handle
clockwise to tighten, seal and lock the tank cover.