Full Product Manual

ASSEMBLY INSTRUCTIONS

Assemble Pump Handle

Slide handle onto shaft and line up holes. Thread bolt through handle

and shaft and securely tighten. Thread on lock nut and tighten using

a 13mm (or adjustable) wrench. Handle can be mounted on left or

right depending on user preference. (See Figure D)

Assemble Extension, Shut-O , Nozzle and Spray

Optimizer

1. Install the extension “wand” onto the shut-o

assembly and tighten the nut securely. (See Figure A)

2. (Optional) Install Spray Optimizer for low pressure (low

drift) applications. This will help prevent weed killer

formulas from drifting into undesired areas. (Do not

over tighten, actual position will vary. See Figure B)

3. Install selected nozzle onto the end of the extension

or optimizer (if installed) and tighten securely.

(See Figure C)

Figure A

Figure B

(Optional)

Figure C

Figure D

Folding Handle

1. Thread bolt through handle

and shaft as stated above.

2. Snap strap around

handle.

3. Handle shown in

folded position.

Page 3

SELECT USING NOZZLE CHART BELOW

(Nozzle selections vary by model)

A. Cap Nut

B. Foaming Nozzle/High-Volume

Foaming Nozzle

C. Red High-Volume Fan Nozzle

D. Yellow Low-Volume Fan Nozzle

E. Adjustable Cone Nozzle

F. Flat Seal

G. Adapter