User Manual

Page 3
OPERATION INSTRUCTIONS
Assembling
NOTE: Before each use, be sure nozzle cap on fogger
is tightened securely.
1. With fogger unplugged, Inspect nozzle cap by pulling barrel
away from fogger body as shown. (See Figure 1)
2. Inspect nozzle for any accumulation of any foreign matter.
Clean nozzle if needed before using and secure nozzle tightly.
(See Figure 2)
3. Attach barrel by positioning the prongs directly in line with the
slots provided for them in the housing. Push the barrel  rmly
into place being careful not to twist or bend the prongs.
(See Figure 3)
4. Barrel should snap into place. Do not leave any gap between
fogger body and barrel as shown. (See Figure 4)
3. After  lling container with (oil based) chemical, be sure latches
are fastened securely to lid as shown. (See Figure 5)
4. Plug in cord to the proper grounded electrical outlet (voltage is indicated on fogger housing.)
5. Extension cords must be 3-wire, 10, 12 or 14-gauge. Long lengths of lighter cord will not conduct the
necessary current to the heating chamber, and may result in insu cient heating and insecticide
leakage from the end of the barrel. Over heating of the extension cord may also occur.
CAUTION: • Use only extension cords which are intended for outdoor use and have an electrical rating not
less than the rating on the fogger nameplate.
• Examine your extension cord carefully before using. Do not use if damaged.
• Do not abuse the extension cord and do not yank on any cord to disconnect.
• Keep the cord away from heat and sharp edges.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
NOZZLE CAP