User Guide

ManualsBrandsSmith Corona ManualsOtherDISPLAYCHAPTER3

3-2 — Type Mode Smith Corona Corporation

Corrections

The typewriter can automatically correct all characters in a one-line

memory buffer. You can easily correct characters not in the correction

memory buffer by performing an extra step (see “Off-Line Correction”).

If End of Page is activated, remember to use Index Up/Index Down,

Return, Back Space, and Spacebar when positioning the print hammer to

make a correction. If you use the platen knob, the line count may be

inaccurate.

IMPORTANT: If you changed printwheels, be sure to insert the

proper printwheel before making corrections.

IMPORTANT: When correcting Bold or Underscore characters, you

must reactivate Bold and/or Underscore before

turning on the correction feature or correction will

not occur.

Erasing Character(s) in Correction Memory

1. Position the print hammer on the incorrect character, then press

Correct. Hold down to continue erasing characters to the left. Do not

use the platen knob to position the print hammer.

2. Type the correction.

3. Press Code + Reloc (Return) to quickly return to your previous

typing position, if necessary.

NOTE: You erase correction memory when you press Return,

turn off the typewriter, use Automatic Paper Insert,

switch modes, or change pitch.

WordEraser

This feature allows you to erase word(s) within correction memory.

1. Position the print hammer on any character in the incorrect word

or to the space to the right of the word. If you are correcting more

than one word, position the print hammer on the right-most

incorrect word.

2. Press WordEraser once for each incorrect word. The error is erased.

3. Type in the correction.

4. Press Code + Reloc (Return) to return to your previous typing

position, if necessary.

Position Print Hammer

Type Correction

Code

Reloc

Return