Instruction manual

Installation
14
CONNECTING TO THE WATER
SUPPLY
Connect the intake hose to a cold
water supply with ¾” gas thread,
inserting the filter A
supplied with the
dishwasher.
Take care to screw the
hose firmly into place with your
hands and then complete by
tightening about ¼ of a turn with
pliers.
In dishwashers equipped with the
AQUASTOP device, the filters is
already fitted inside the threaded
ring.
The dishwasher can also be connected to a hot
water supply not exceeding 60°C
. Supplying
the appliance with hot water cuts down the
washing time be approximately 20 minutes, but
slightly reduces its effectiveness. Make the
connection to the domestic hot water supply
using the same procedure described for
connecting to the cold wate
r supply.