User manual

16
FAULT
DESCRIPTION
E6
Water pump-out malfunction
The appliance does not pump out the water or
does so incorrectly. Make sure the drain hose is
not kinked or crushed and that the siphon and
lters are not clogged.
If the problem persists, contact the technical as-
sistance service.
E7
Turbine ow-regulator malfunction
(only for models tted with this feature)
The appliance is unable to precisely measure the
quantity of incoming water. Interrupt the current
program and switch o the dishwasher. Switch it
back on again, program a new cycle and press start.
If the problem persists, contact the technical assis-
tance service.
E8
Alternate washing system malfunction
Interrupt the current program and switch o
the dishwasher. Switch it back on again, program
a new cycle and press start. If the problem per-
sists, contact the technical assistance service.
E9
Water intake system malfunction
Contact the technical assistance service.
E11
Wash motor pump does not work
Tab. 4-01a
Light o Light on Light ashing
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
• Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.
• The E5, E6 alarms interrupts the running program once the cause is
resolved, it
will bring bach the execution of the program.
• The alarm E7 is visualized at the end of the cycle that comes, however,
brought to
the end since the operation of the dishwasher is not harmed.
• E11: Contact the after-sales service.
To “reset” an alarm is necessary:
Open and close the door, or turn o and on the machine. At this point is
possible to program the dishwasher again.
USER INSTRUCTIONS
EN