Instruction manual

User instructions
19
ADJUSTING THE APPLIANCE’S POWER SETTING
The dishwasher leaves the factory in single-phase version. The power can be
set at three different levels as shown below.
Power kW Fuse
P3-Max 5,45 3x16
A
P2-Medium 3,50 3x16
A
P3-Max: Factory setting
P1-Min 2,00 3x16
A
To adjust the power setting, proceed as follows:
Set a washing program other than the soak program.
Press the button indicated (depending on the model) until P3 appears on the
display (maximum power).
Pressing the button again will cause the setting to move to “P1” (minimum
power) and then to “P2” (mediumm power).
The menu closes automatically after a few seconds or you can exit by pressing
any of the other buttons.