User manual

Installation
19
EN
Hob seal
To prevent leakage of liquid between the
frame of the hob and the work surface,
place the insulating seal provided in
position before assembly, as shown in the
figure below.
1. Refer to the dimensions in the figure,
bearing in mind that all the sides "A" of
the seal must brush against the hole.
2. Use light pressure to make the seal stick
to the edge around the hole cut in the
worktop.
3. Carefully trim the surplus away from
edge (C) beyond the seal.
5.4 Fixing to the supporting structure
Secure the hob to the piece of furniture
through the appropriate bracket (A).
5.5 Gas connection
Do not fix the hob using silicone.
This would make it impossible to
remove the hob, if necessary,
without damaging it.
Gas leak
Danger of explosion
• After carrying out any operation, check
that the tightening torque of gas
connections is between 10 Nm and
15 Nm.
• If required, use a pressure regulator that
complies with current regulations.
• At the end of the installation, check for
any leaks with a soapy solution, never
with a flame.
• The hoses should not come into contact
with moving parts and should not be
crushed in any way.
• The settings for this domestic appliance
are shown on the gas setting label.