User manual

Installation
14
This range is equipped with a factory-
connected power cord. The cord must be
connected to a grounded 120/240 volt or
120/208 volt outlet. If no outlet is
available, have one installed by a qualified
electrician.
See the rating plate for technical
specifications.
The rating plate is visibly located on the
right side of the oven door frame.
This ID plate must never be removed.
1.4 Wall and floor attachment
WARNING
Electrical shock hazard
• Disconnect the electrical supply before
servicing the appliance
• It is the personal responsibility of the
consumer to have the appropriate outlet
or junction box with the correct, properly
grounded wall receptacle installed by a
qualified electrician. It is the
responsibility and obligation of the
consumer to contact a qualified installer
to ensure that the electrical installation is
suitable and in conformance with all
local codes and ordinances.
CAUTION
Do not use multiple outlets, extension
cords or adapters.
WARNING
Electrical shock hazard
•Use extreme caution
when drilling holes in the
wall or floor. There may
be concealed electrical
wiring behind the wall or
under the floor.
• Identify the location of the electrical
circuits that could be affected by the
installation of the anti-tip device, then
turn off power to these circuits.
• Failure to follow these instructions may
result in electrical shock or other
personal injury.