Installation Instructions

Installation
13
EN
Cabinet clearances
Clearance L can have the following values:
• L = 30” (762 mm) min. when the bottom
of wood or metal cabinet is protected by
not less than ¼” (0.64 cm) flame
retardant millboard covered with not less
than No. 28 MSG sheet steel, 0.015"
(0.4 mm) stainless steel, 0.024" (0.6
mm) aluminum or 0.020" (0.5 mm)
copper.
• L = 36" (914 mm) min. clearance
between the top of the cooking surface
and the bottom of an unprotected wood
or metal cabinet.
1
min. clearance from the sides of range to
side wall or other combustible material;
2
min. cabinet opening width;
3
upper cabinet to countertop;
4
max. upper cabinet depth.
The side cabinet depth (clearance B) must
match the front edge of the range side
panel.
A 36" 914 mm
B 25” 630 mm
C
1
20" 508 mm
G
2
36" 914 mm
I
3
18" 457 mm
L see notes below
M
4
13" 330 mm
P
4
13" 330 mm
The distance between the
appliance and the rear wall below
the worktop is zero.
The distance between the
appliance and the side cabinets
below the worktop is zero.
Any opening in the wall behind the
appliance and in the floor under
the appliance shall be sealed.